- AD VA NCE D IN F O RMA T IO N -

16

Dust Networks

LTP5903-WHR Datasheet

4. An unintentional radiator scan must be performed on the device integrating the LTP5903-WHR Embedded Manager, per

FCC rules and regulations, CFR Title 47, Part 15, Subpart B. See FCC rules for specifics on requirements for declaration

of conformity.

10.1.2

FCC-approved Antenna

The following are FCC-approved antenna specifications for the LTP5903-WHR.

Table 25 FCC-approved Antenna Specifications for the LTP5903-WHR

Gain

Pattern

Polarization

Frequency

Connector

+2 dBi maximum

Omni-directional

Vertical

2.4–2.4835 GHz

MMCX

10.1.3

OEM Labeling Requirements

The Original Equipment Manufacturer (OEM) must ensure that FCC labeling requirements are met. The outside of the final

product enclosure must have a label with the following (or similar) text specifying the FCC identifier. The FCC ID and

certification code must be in Latin letters and Arabic numbers and visible without magnification.

Contains transmitter module FCC ID: SJC-M2140

or

Contains FCC ID: SJC-M2140

10.2

IC Compliance

10.2.1

IC Testing

The LTP5903-WHR is certified for modular Industry Canada (IC) RSS-210 approval. The OEM is responsible for its product

to comply with IC ICES-003 and FCC Part 15, Sub. B - Unintentional Radiators. The requirements of ICES-003 are

equivalent to FCC Part 15 Sub. B and Industry Canada accepts FCC test reports or CISPR 22 test reports for compliance with

ICES-003.

10.2.2

IC-approved Antennae

The LTP5903-WHR is designed to operate with antennas meeting the specifications shown in Table 26. Antennas not

meeting these specifications are strictly prohibited for use with the LTP5903-WHR. The required antenna impedance is 50

Ohms. Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device

must accept any interference, including interference that may cause undesired operation of the device.

Table 26 IC-approved Antenna Specifications for the LTP5903-WHR

Gain

Pattern

Polarization

Frequency

Connector

+2 dBi maximum

Omni-directional

Vertical

2.4–2.4835 GHz

MMCX

The following are IC-approved antenna specifications for the LTP5903-WHR.

10.2.3

OEM Labeling Requirements

The Original Equipment Manufacturer (OEM) must ensure that IC labeling requirements are met. The outside of the final

product enclosure must have a label with the following (or similar) text specifying the IC identifier. The IC ID and

certification code must be in Latin letters and Arabic numbers and visible without magnification.

Contains IC: 5853A-M2140