CT2579 datasheet(3/41 Pages) AEROFLEX

3 / 41 page

APPLICATION NOTE #108

Released 9/98

Signal Descriptions

MIL-STD-1553 Bus Interface Signals

Data0(Bus)

Connect to positive side of the external databus transformer for Bus 0

Ndata0(Bus) Connect to negative side of the external databus transformer for Bus 0

Data1(Bus)

Connect to positive side of the external databus transformer for Bus 1

Ndata1(Bus) Connect to negative side of the external databus transformer for Bus 1

Hard Wired Interface Signals

AddrA-E

Remote Terminal address inputs for the unit. ADDR A is the least significant bit and

ADDR E is the most significant bit. RT Address inputs for the unit. AddrA is the LSB,

AddrE is the MSB.

AddrP

Parity Bit for the RT Address inputs. AddrP must be set to ODD parity

MACAIR

This signal sets the unit to respond with a status word within 4 uS (dead bus time)

while in Remote Terminal mode. Subaddress 1F is also enabled to be a valid

subaddress for data.

Normally subaddress 00 and 1F are reserved for mode codes.

“1" = 4 uS dead bus response time, subaddress 1F used for data.

“0" = 12 uS response time, subaddress 1F used for mode codes.

NBIT16

Select 8 or 16 bit subsystem data interface. In 8 bit mode only the lower 8 bits of the

databus (DATA 0-7) are used for all data transfers. If left open circuit the device will

default to 16 bit mode.

"0" = 16 Bit Mode

"1" = 8 Bit Mode

VME

Select VME or MULTIBUS subsystem interface. If left open circuit the device will

default to VME mode.

"0" = Multibus Mode

"1" = VME Mode

*WRAPEN

Select Remote Terminal wrap around to subaddress 1E. For this test to work correctly

theunit must be in RT mode. The Bus Controller sends data to subaddress 1E which

remains in the data buffer memory and is available to be sent back on the very next

command by the Bus Controller. The data in the data buffer memory in this mode

does not get transferred to the main RAM. If the very next command is not a transmit

command to subaddress 1E, the data buffer memory is flushed and will respond

normally to the next set of commands. If the wrap around test is enabled, data to

subaddress 1E must be transferred in the correct sequence.

"0" = Normal Mode

"1" = Wrap Around Mode

MIL-STD-1760 Signals

NENCHK

Enables / Disables the internal hardware checksum generation and validation for both

Remote Terminal and Bus Controller. When enabled, the circuitry will check all

CT2579 데이터시트(PDF) 3 Page - Aeroflex Circuit Technology

CT2579 데이터시트(HTML) 3 Page - Aeroflex Circuit Technology

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41

데이터시트 다운로드

링크 URL