R4430PCF10MCM datasheet(7/11 Pages) AEROFLEX

7 / 11 page

SCD4430 Rev A 11/18/96

Interrupt Interface Signals: These signals comprise the interface used by

external agents to interrupt the R4400 processor

Int(5:1)*

Interrupt

: Five of six general processor interrupts, bit-

wise ORed with bits 5:1 of the interrupt register. This

feature available on the R4400PC version only

Int0*

Interrupt:

One of six general processor interrupts, bit

wise ORed with bit 0 of the interrupt register

NMI*

Nonmaskable interrupt

: Nonmaskable interrupt ORed

with bit 6 of the interrupt register

Initialization Interface: These signals comprise the interface by which an

external agent initializes the R4400 operating parameters.

ColdReset*

Cold Reset:

This signal must be asserted for a power on

reset or a cold reset. The clocks SClock, TClock, and

RClock begin to cycle and are synchronized with the

de-assertion edge of ColdReset*. ColdReset must be de-

asserted synchronously with MasterOut.

ModeClock

Boot Mode Clock:

Serial boot-mode data clock output

at the system clock frequency divided by 256

ModeIn

Boot mode data in:

Serial boot-mode data input.

Reset*

Reset:

This signal must be asserted for any reset

sequence. It may be asserted synchronously or asyn-

chronously for a cold reset, or synchronously to initate

a warm reset. Reset must be de-asserted synchronously

with MasterOut.

VccOk

Vcc is OK:

When asserted, this signal tells the R4400

that the 3.3 Volt power supply has been above 3.15

Volts for more than 100 milliseconds & will remain sta-

ble . Assertion of VccOK starts initialization sequence.

256K/1M*

Cache size Select:

Must be connected to ground to

enable the full 1M Byte of cache. Cache size will be

256K if pin is left unconnected.

JTAG Interface Signals

JTDI

JTAG data in:

Data is serial, scanned in thru this pin

JTCK

JTAG clock input:

The processor outputs a serial clock

on JTCK. On the rising edge of JTCK, both JTDI and

JTMS are sampled.

JTDO

JTAG data out:

Data is serial, scanned out thru this pin

JTMS

JTAG:

JTAG command signal indicates that the incom-

ming serial data is command clear.

R4430PCF10MCM 데이터시트(PDF) 7 Page - Aeroflex Circuit Technology

R4430PCF10MCM 데이터시트(HTML) 7 Page - Aeroflex Circuit Technology

Html Pages

1 2 3 4 5 6 7 8 9 10 11

데이터시트 다운로드

링크 URL