OR3C80 datasheet(40/210 Pages) AGERE

40 / 210 page

Lucent Technologies Inc.

Data Sheet

June 1999

ORCA Series 3C and 3T FPGAs

Programmable Input/Output Cells (continued)

Input Demultiplexing

The combination of input register capability and the two inputs, IN1 and IN2, from each PIO to the internal routing

provides for input signal demultiplexing without any additional resources. Figure 24 shows the input configuration

and general timing for demultiplexing a multiplexed address and data signal. The PIO input signal is sent to both

the input latch and directly to IN2. The signal is latched on the falling edge of the clock and output to routing at IN1.

The address and data are then both available at the rising edge of the system clock. These signals may be regis-

tered or otherwise processed in the PLCs at that clock edge. Figure 24 also shows the possible use of the SLIC

decoder to perform an address decode to enable which registers are to receive the input data. Although the timing

shown is for using the input register as a latch, it may also be used in the same way as an FF. Also note that the sig-

nals found in PIO inputs IN1 and IN2 can be interchanged.

5-5798(F)

Figure 24. PIO Input Demultiplexing

DEC

PAD

PIO

SLIC

OTHER ADDRESS

LINES

SCLK

IN1

IN2

SCLK

PIO LATCH

PLC FF

ADDR1

ADDR2

ADDR3

ADDR4

ADDR5

DATA1

DATA2

DATA3

DATA4

DATA1

DATA2

DATA3

ADDR2

ADDR3

ADDR4

ADDR5

DATA0

DATA4

OUTPUT

PIO INPUT

PLC

OR3C80 데이터시트(PDF) 40 Page - Agere Systems

OR3C80 데이터시트(HTML) 40 Page - Agere Systems

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

데이터시트 다운로드

링크 URL