STM8S103F3P3 datasheet(25/113 Pages) STMICROELECTRONICS

부품명	STM8S103F3P3

상세설명	Access line, 16 MHz STM8S 8-bit MCU, up to 8 Kbytes Flash, data EEPROM,10-bit ADC, 3 timers, UART, SPI, I2C

PDF	113 Pages

Scroll/Zoom	100%

제조업체	STMICROELECTRONICS [STMicroelectronics]

홈페이지	http://www.st.com

Logo

25 / 113 page

(1)

I/O pins used simultaneously for high current source/sink must be uniformly spaced around the package. In addition, the total driven current must respect the absolute

maximum ratings.

(2)

When the MCU is in halt/active-halt mode, PA1 is automatically configured in input weak pull up and cannot be used for waking up the device. In this mode, the output

state of PA1 is not driven. It is recommended to use PA1 only in input mode if halt/active-halt is used in the application.

(3)

In the open-drain output column, "T" defines a true open-drain I/O (P-buffer and protection diode to VDD are not implemented).

Alternate function remapping

5.3

As shown in the rightmost column of the pin description table, some alternate functions can

be remapped at different I/O ports by programming one of eight AFR (alternate function

remap) option bits. When the remapping option is active, the default alternate function is no

longer available.

To use an alternate function, the corresponding peripheral must be enabled in the peripheral

registers.

Alternate function remapping does not effect GPIO capabilities of the I/O ports (see the GPIO

section of the family reference manual, RM0016).

25/113

DocID15441 Rev 6

Pinout and pin description

STM8S103K3 STM8S103F3 STM8S103F2

STM8S103F3P3 데이터시트(PDF) 25 Page - STMicroelectronics

STM8S103F3P3 데이터시트(HTML) 25 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

데이터시트 다운로드

링크 URL