QG80331M500 datasheet(34/67 Pages) INTEL

34 / 67 page

Specification Update

Intel® 80331 I/O Processor

Non-Core Errata

47.

VCCDDR (VCC25/VCC18) Current Spike

Problem:

An internal DDR signal gets routed through logic that is powered by the VCC15 rail. This signal

gets driven to the wrong level when VCC15 rail is not powered up. This signal controls the input

and output enable of all DDR buffers, so when VCC15 is off and VCC25/18 is on, it asserts high

and cannot tristate the DDR outputs. The issue can occur at power-up, power down and power fail

when battery back-up continues to power the 80331.

Implication:

Excessive VCC25/18 power supply rail current to the VSS rail is experienced until VCC15 core

supply is up.

Also, when using DDR-I mode (VCC25), the buffers can be overstressed when VCC15 = off and

VCC25 = on. This can cause a reliability problem since the processor may become damaged over

time.

When in DDR-II mode (VCC18), the buffers do not overstress since VCC18 maximum is 1.9 V.

Therefore, no reliability problems exist.

Workaround:

A new power sequencing requirement should be followed for B-0 and C-0 steppings. This problem

does not affect A-1 stepping, and is being fixed in C-1 stepping.

1. VCC33 power up

2. VCC15 power up

3. VCC25/18 power up

The VCC15 minimum supply voltage has to be within 25% of the VCC25 supply voltage, until the

VCC15 supply reaches 1.425 V (VCC15 minimum), during power-up and power-down sequences.

This is the minimum requirement to ensure no gate overstress when using DDR-I memory.

For power-fail condition, the battery should power only the DIMM. The 80331 should be isolated

from the battery power.

Status:

Fixed. Fixed in C-1 stepping. See the Table , “Summary Table of Changes” on page 9.

QG80331M500 데이터시트(PDF) 34 Page - Intel Corporation