VND830E datasheet(10/20 Pages) STMICROELECTRONICS

10 / 20 page

VND830-E

10/20

µC I/Os PROTECTION:

If a ground protection network is used and negative

transient are present on the VCC line, the control pins will

be pulled negative. ST suggests to insert a resistor (Rprot)

in line to prevent the

µC I/Os pins to latch-up.

The value of these resistors is a compromise between the

leakage current of

µC and the current required by the

HSD I/Os (Input levels compatibility) with the latch-up

limit of

µC I/Os.

-VCCpeak/Ilatchup

≤ Rprot ≤ (VOHµC-VIH-VGND) / IIHmax

Calculation example:

For VCCpeak= - 100V and Ilatchup

≥ 20mA; VOHµC ≥ 4.5V

Ω ≤ Rprot ≤ 65kΩ.

Recommended Rprot value is 10k

Ω.

OPEN LOAD DETECTION IN OFF STATE

Off state open load detection requires an external pull-up

resistor (RPU) connected between OUTPUT pin and a

positive supply voltage (VPU) like the +5V line used to

supply the microprocessor.

The external resistor has to be selected according to the

following requirements:

1) no false open load indication when load is connected:

in this case we have to avoid VOUT to be higher than

VOlmin; this results in the following condition

VOUT=(VPU/(RL+RPU))RL<VOlmin.

2) no misdetection when load is disconnected: in this

case the VOUT has to be higher than VOLmax; this

results in the following condition RPU<(VPU–VOLmax)/

IL(off2).

Because Is(OFF) may significantly increase if Vout is

pulled high (up to several mA), the pull-up resistor RPU

should be connected to a supply that is switched OFF

when the module is in standby.

The values of VOLmin, VOLmax and IL(off2) are available in

the Electrical Characteristics section.

Figure 8. Open Load detection in off state

VOL

V batt.

VPU

RPU

DRIVER

LOGIC

INPUT

STATUS

VCC

OUT

GROUND

IL(off2)

Obsolete

Product(s)

- Obsolete

Product(s)

VND830E 데이터시트(PDF) 10 Page - STMicroelectronics

VND830E 데이터시트(HTML) 10 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20

데이터시트 다운로드

링크 URL