Model 96 PC Pin Terminals, In-Line

120 ° ± 5 ° STD.

FLAT ORIENTATION

(SHAFT AT CCW END)

1

3

CCW

2

POTENTIOMETER

Shaft Flat Orientation

DIA.

13.72 ± 0.38

(.540 ± .015)

15.88

(.625)

12.95 ± .203

(.510 ± .008)

MOUNTING

SURFACE

L

0.76 ± 0.05

(.030 ± .002)

TYP.

BACK VIEW

2.54

(.100)

2.54

(.100)

0.79 ± .025

(.031 ± .010)

1.19

(.047)

“A” STYLE

A.R. LUG

R

1.37 ± 0.08

(.054 ± .003)

2.36 ± 0.08

(.093 ± .003)

7.92

(.312)

9.53

(.375)

15.29 ± 0.56

(.602 ± .022)

SEE HOW TO ORDER

CHART FOR

BUSHING OPTIONS.

SEE

NEXT PAGE

FOR SHAFT

OPTIONS.

3

2

1

R1

11.05 ± 0.20

(.435 ± .008)

TOLERANCES EXCEPT AS SHOWN: DECIMAL .XXX ±

(.015 )

FRACTION ± 1/64

.XX ±

(.38)

ANGLE ±5 °

.381

9.65

Specifications are subject to change without notice.

The device characteristics and parameters in this data sheet can and do vary in different applications and actual device performance may vary over time.

Users should verify actual device performance in their specific applications.

Stop Strength (1/4 ” D shaft) .............................................................................................................................................45.19 N-cm (4 lb.-in.)

(1/8 ” D shaft) .............................................................................................................................................33.89 N-cm (3 lb.-in.)

Mechanical Angle.................................................................................................................................................................................300 ° ±5 °

Torque

Starting ........................................................................................................................................... 0.3 max. above average running torque

Running Torque

Single or Dual Section (A & R Bushings) .................................................................................................. 0.21 to 1.06 N-cm (0.3 to 1.5 oz.-in.)

Single or Dual Section (C & U Bushings).................................................................................................. 0.14 to 1.06 N-cm (0.2 to 1.5 oz.-in.)

Mounting .............................................................................................................................................1.7-2.0 N-m (15-18 lb.-in.) maximum

Variation...................................................................................................................... 0.35 N-cm (0.5 oz.-in.) maximum in 45 ° shaft travel

Weight (Single Section, Metal Bushing)...............................................................................................................................12.7 grams nominal

Terminals .................................................................................................................................Printed circuit terminals, J-Hooks or solder lugs

Soldering Condition ...........................................Recommended hand soldering using Sn95/Ag5 no clean solder, 0.025 ” wire diameter.

Maximum temperature 399 °C (750 °F) for 3 seconds. Immersion wash is not recommended.

Marking ..................................................................................Manufacturer’s trademark, date code, resistance, manufacturer’s part number

Hardware...................One lockwasher and one mounting nut is shipped with each potentiometer, except where noted in the part number.

NOTE:

Performance specifications do not apply to units subjected to printed circuit board immersion cleaning processes.

Product Dimensions

Model 96 - 5/8 ” Square Sealed Single-Turn Panel Control

DIMENSIONS:

MM

(INCHES)