13

ASIX Multi-Port Ethernet Controller

Product Introduction

6-3. AX88782 SMDK2440 Demo Board

The following is the picture of AX88782 SMDK2440 demo board for your reference.

Figure 12. AX88782 SMDK2440 Demo Board

The following are the jumper configuration table of the AX88782 SMDK2440 demo board.

Jumper

Setting

Description

(Default)

Set to 16-bit CPU interface mode.

J4(MODE0)

Set to 8-bit CPU interface mode.

(Default)

Pull high the PME signal. The PME signal should be

pulled high when the PME pin is set to active low.

Pull down the PME signal. The PME signal should be

pulled down when the PME pin is set to active high.

(Default)

Pull high the INT signal. The INT signal should be

pulled high when the INT pin is set to active low.

Pull down the INT signal. The INT signal should be

pulled down when the INT pin is set to active high.

Figure 13. AX88782 SMDK2440 Demo Board Jumper Setting Table

Note:

1. The J5 header is not set on AX88782 SMDK2440 demo board since the PME signal is not

supported on the SMDK2440 interface.

2. The J6 header is not set on AX88782 SMDK2440 demo board since the INT signal has been

pulled high on the SMDK2440 platform.

Copyright (C) 2008-2009 Reserved by ASIX Electronics Corporation