TS30013 datasheet(4/18 Pages) ETC2

4 / 18 page

- 4 -

TS30011/12/13

Version 1.6

Specifications subject to change

WWW.TRIUNESYSTEMS.COM

ABSOLUTE MAXIMUM RATINGS

Over operating free–air temperature range unless otherwise noted(1, 2)

Parameter

Value

Unit

VCC

-0.3 to 26.4

(-0.3 to 20 for TS30013)

BST

-0.3 to (VCC+6)

VSW

-1 to 26.4

(-1 to 20 for TS30013)

EN, PG,FB

-0.3 to 6

Electrostatic Discharge – Human Body Model

+/-2k

Electrostatic Discharge – Charge Device Model

+/-500

Lead Temperature (soldering, 10 seconds)

260

C

(1) Stresses beyond those listed under “absolute maximum ratings” may cause permanent damage to the device. These are stress ratings only and functional

operation of the device at these or any other conditions beyond those indicated under “recommended operating conditions” is not implied. Exposure to

absolute–maximum–rated conditions for extended periods may affect device reliability.

(2) All voltage values are with respect to network ground terminal.

THERMAL CHARACTERISTICS

Symbol

Parameter

Value

Unit

JA

Thermal Resistance Junction to Air (Note 1)

34.5

°C/W

JC

Thermal Resistance Junction to Case (Note 1)

2.5

°C/W

TSTG

Storage Temperature Range

-65 to 150

°C

TJ MAX

Maximum Junction Temperature

150

°C

Operating Junction Temperature Range

-40 to 125

°C

Note 1: Assumes 16LD 3x3 QFN with hi-K JEDEC board and 13.5 inch2 of 1 oz Cu and 4 thermal vias connected to PAD

RECOMMENDED OPERATING CONDITIONS

Symbol

Parameter

Min

Typ

Max

Unit

VCC

Input Operating Voltage

4.5

(18 for TS30013)

CBST

Bootstrap Capacitor

17.6

26.4

LOUT

Output Filter Inductor Typical Value (Note 1)

3.76

4.7

5.64

COUT

Output Filter Capacitor Typical Value (Note 2)

44 (2 x 22)

COUT-ESR

Output Filter Capacitor ESR

100

m

CBYPASS

Input Supply Bypass Capacitor Typical Value (Note 3)

Note 1: For best performance, an inductor with a saturation current rating higher than the maximum VOUT load requirement plus the inductor current ripple.

Note 2: For best performance, a low ESR ceramic capacitor should be used.

Note 3: For best performance, a low ESR ceramic capacitor should be used. If CBYPASS is not a low ESR ceramic capacitor, a 0.1uF ceramic capacitor should be

added in parallel to CBYPASS.

TS30013 데이터시트(PDF) 4 Page - List of Unclassifed Manufacturers

TS30013 데이터시트(HTML) 4 Page - List of Unclassifed Manufacturers

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18

데이터시트 다운로드

링크 URL