MP2560 – 2.5A, 4MHz, 42V STEP-DOWN CONVERTER

MP2560 Rev. 1.2

www.MonolithicPower.com

13

1/25/2010

MPS Proprietary Information. Unauthorized Photocopy and Duplication Prohibited.

© 2010 MPS. All Rights Reserved.

In this case (as shown in Figure 2), a third pole

set by the compensation capacitor (C6) and the

compensation

resistor

(R3)

is

used

to

compensate the effect of the ESR zero on the

loop gain. This pole is located at:

3

R

6

C

2

1

P

×

×

π

=

The goal of compensation design is to shape

the converter transfer function to get a desired

loop gain. The system crossover frequency

where the feedback loop has the unity gain is

important. Lower crossover frequencies result

in slower line and load transient responses,

while higher crossover frequencies could cause

system unstable. A good rule of thumb is to set

the crossover frequency to approximately one-

tenth of the switching frequency. The Table 3

lists the typical values of compensation

components for some standard output voltages

with various output capacitors and inductors.

The values of the compensation components

have

been

optimized

for

fast

transient

responses and good stability at given conditions.

Table 3—Compensation Values for Typical

Output Voltage/Capacitor Combinations

(V)

L1 (µH)

C2

(µF)

R3

(kΩ)

C3

(pF)

C6

1.8

4.7

47

105

100

None

2.5

4.7 - 6.8

33

54.9

330

None

3.3

6.8 -10

22

68.1

220

None

5

15 - 22

22

100

150

None

12

22

33

147

150

None

To optimize the compensation components for

conditions not listed in Table 3, the following

procedure can be used.

1. Choose the compensation resistor (R3) to set

the desired crossover frequency. Determine the

R3 value by the following equation:

FB

OUT

CS

EA

C

V

V

G

G

f

2

C

2

3

R

×

×

×

×

π

=

2. Choose the compensation capacitor (C3) to

achieve

the

desired

phase

margin.

For

applications with typical inductor values, setting

the crossover frequency provides sufficient

phase margin. Determine the C3 value by the

following equation:

C

f

3

R

2

4

3

C

×

×

π

>

3. Determine if the second compensation

capacitor (C6) is required. It is required if the

ESR zero of the output capacitor is located at

less than half of the switching frequency, or the

following relationship is valid:

2

f

R

2

C

2

1

S

ESR

<

×

×

π

If this is the case, then add the second

at the location of the ESR zero. Determine the

C6 value by the equation:

3

R

R

2

C

6

C

ESR

×

=