24LC21TIP datasheet(5/24 Pages) MICROCHIP

5 / 24 page

 2004 Microchip Technology Inc.

DS21095J-page 5

24LC21

3.0

BIDIRECTIONAL MODE

The 24LC21 can be switched into the Bidirectional

mode (see Figure 3-1) by applying a valid high-to-low

transition on the Bidirectional mode clock (SCL). When

the device has been switched into the Bidirectional

mode, the VCLK input is disregarded, with the exception

that a logic high level is required to enable write capa-

bility. This mode supports a two wire bidirectional data

transmission protocol. In this protocol, a device that

sends data on the bus is defined to be the transmitter,

and a device that receives data from the bus is defined

to be the receiver. The bus must be controlled by a

master device that generates the Bidirectional mode

clock (SCL), controls access to the bus and generates

the Start and Stop conditions, while the 24LC21 acts as

the slave. Both master and slave can operate as

transmitter

receiver,

but

the

master

device

determines which mode is activated.

3.1

Bidirectional Mode Bus

Characteristics

The following bus protocol has been defined:

• Data transfer may be initiated only when the bus

is not busy.

• During data transfer, the data line must remain

stable whenever the clock line is high. Changes in

the data line while the clock line is high will be

interpreted as a Start or Stop condition.

Accordingly, the following bus conditions have been

defined (see Figure 3-2).

3.1.1

BUS NOT BUSY (A)

Both data and clock lines remain high.

3.1.2

START DATA TRANSFER (B)

A high-to-low transition of the SDA line while the clock

(SCL) is high determines a Start condition. All

commands must be preceded by a Start condition.

3.1.3

STOP DATA TRANSFER (C)

A low-to-high transition of the SDA line while the clock

(SCL) is high determines a Stop condition. All

operations must be ended with a Stop condition.

FIGURE 3-1:

MODE TRANSITION

FIGURE 3-2:

DATA TRANSFER SEQUENCE ON THE SERIAL BUS

SCL

SDA

VCLK

Bidirectional mode

TVHZ

Transmit-only mode

(A)

(B)

(D)

(A)

(C)

Start

Condition

Address or

Acknowledge

Valid

Data

Allowed

to Change

Stop

Condition

SCL

SDA

24LC21TIP 데이터시트(PDF) 5 Page - Microchip Technology

24LC21TIP 데이터시트(HTML) 5 Page - Microchip Technology

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24

데이터시트 다운로드

링크 URL