PIC14000 datasheet(83/153 Pages) MICROCHIP

83 / 153 page

Preliminary

DS40122B-page 83

PIC14000

10.6.1

EXTERNAL INTERRUPT

An external interrupt can be generated via the

OSC1/PBTN pin if IN (internal oscillator) mode is

enabled. This interrupt is falling edge triggered. When

a valid edge appears on OSC1/PBTN pin, PBIF

(PIR1<4>) is set. This interrupt can be disabled by

clearing PBIE (PIE1<4>). PBIF must be cleared in soft-

ware in the interrupt service routine before re-enabling

the interrupt. This interrupt can wake up the processor

from SLEEP if PBIE bit is set (interrupt enabled) prior

to going into SLEEP mode. The status of the GIE bit

determines whether or not the processor branches to

the interrupt vector following wake-up. The timing of the

external interrupt is shown in Figure 10-10.

FIGURE 10-10: EXTERNAL (OSC1/PBTN) INTERRUPT TIMING

INTERNAL

CLKOUT(3)

PBTN pin

PBIF ﬂag

(PIR<4>)

GIE bit

(INTCON<7>)

INSTRUCTION FLOW

Instruction

fetched

Instruction

executed

Interrupt Latency

PC+1

0004h

0005h

Inst (0004h)

Inst (0005h)

Dummy Cycle

Inst (PC)

Inst (PC+1)

Inst (PC-1)

Inst (0004h)

Dummy Cycle

Inst (PC)

—

Notes:

1. PBIF ﬂag is sampled here (every Q1)

2. Interrupt latency = 3-4Tcy where Tcy = instruction cycle time.

Latency is the same whether Inst (PC) is a single cycle or a 2-cycle instruction.

3. Available only in IN oscillator mode on OSC2.

4. For minimum width spec of PBTN pulse, refer to AC specs.

5. PBIF is enabled to be set anytime during the Q4-Q1 cycles.

(Note 2)

OSC

PIC14000 데이터시트(PDF) 83 Page - Microchip Technology

PIC14000 데이터시트(HTML) 83 Page - Microchip Technology

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

데이터시트 다운로드

링크 URL