| 전자부품 데이터시트 검색엔진 |
|
STM32F205RB 데이터시트(PDF) 22 Page - STMicroelectronics |
|
|
|||||||||||||||||||||||||||||
STM32F205RB 데이터시트(HTML) 22 Page - STMicroelectronics |
|
22 / 163 page ![]() Description STM32F205xx, STM32F207xx 22/163 Doc ID 15818 Rev 7 Otherwise, PA0 should be asserted low externally during POR until VDD reaches 1.8 V (see Figure 7). In this mode, PA0 cannot be used as a GPIO pin since it allows to reset the part of the 1.2 V logic which is not reset by the NRST pin, when the internal voltage regulator in OFF. ● Regulator OFF/internal reset OFF On WLCSP66 package, this mode activated by connecting REGOFF to VSS and IRROFF to VDD. IRROFF cannot be activated in conjunction with REGOFF. This mode is available only on the WLCSP package. It allows to supply externally a 1.2 V voltage source through VCAP_1 and VCAP_2 pins, in addition to VDD. The following conditions must be respected: –VDD should always be higher than VCAP_1 and VCAP_2 to avoid current injection between power domains (see Figure 6). – PA0 should be kept low to cover both conditions: until VCAP_1 and VCAP_2 reach 1.08 V, and until VDD reaches 1.65 V. – NRST should be controlled by an external reset controller to keep the device under reset when VDD is below 1.65 V (see Figure 7). Figure 6. Startup in regulator OFF: slow VDD slope - power-down reset risen after VCAP_1/VCAP_2 stabilization 1. This figure is valid both whatever the internal reset mode (ON or OFF). |
|
링크 URL |
| ALLDATASHEET 가 귀하에 도움이 되셨나요? [ DONATE ] |
Alldatasheet는? | 광고문의 | 운영자에게 연락하기 | 개인정보취급방침 | 링크 투 데이터시트 | 링크교환 | 제조사별 검색 All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |