141SAPH datasheet(21/60 Pages) ETC2

21 / 60 page

Side Cutters

SIDE CUTTERS

Side Cutters

Erem offers a wide range of precision side cutters.

To establish which cutter is correct for your application

follow the steps below

Oval Head

The most common head shape. For standard cutting applications where access is not the

problem.

Tapered Head

For cutting tasks where easier access is required. The tapered head shape allows better

tip access than the oval head but without much reducing the cutting capability.

Relieved Head

For cutting in confined areas. This is the smallest head shape available. One side is cut

away for access even in confined areas. Due to the cut away the cutting capability is

reduced. Flush tip cutting.

Head Form

Cut

Size

110 mm Small short head for increased cutting resistance.

For almost all cutting applications.

115 mm Longer and finer head.

For cutting applications where easy access is more important than a high cutting capacity.

120 mm Strong version.

For all cutting applications where high cutting capacity is required.

Semi Flush

These blades allow a very high resistance. Will cut from tip to heel, malleable wires like

Copper as well as hard wires. Leaves a pinch at the end of the wire. For all applications

where the cutting type is not so important.

Flush

Allows a flat cut with the same cutting capacities. The edge

of the wire is cut off flat. Thanks to faster penetration into

the component the operator’s effort is substantially redu-

ced. No solder spikes after using wave soldering process.

Super Full Flush

An Erem exclusivity. This absolute full flush cut leaves a

perfect flat surface on cut leads It prevents any pinching

of leads. Flat, clean cut. No cutting rework after soldering.

Soft wires only.

1. Erem Cut

2. Others

Cutting safety device, holds wire scraps.

Can be adapted on all side cutters series 500, 600 and 2200.

Add “W” when ordering, e.g. 595EW

Safety Lead Device

141SAPH 데이터시트(PDF) 21 Page - List of Unclassifed Manufacturers

141SAPH 데이터시트(HTML) 21 Page - List of Unclassifed Manufacturers

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60

데이터시트 다운로드

링크 URL