MCP402XEV datasheet(21/46 Pages) MICROCHIP

21 / 46 page

Installation and Operation

DS51546B-page 17

2.4

FIRMWARE DESCRIPTION

The 000066_MCP402XEV.ASM source code was written using assembly language for

the PIC10F206 microcontroller. Refer to Appendix E. “00066_MCP402XEV.ASM

Source Code”. The firmware initializes its I/O so that it can poll the INCR and DECR

buttons every millisecond. If the button has been depressed for 40 out of 50 ms, it is

considered to be debounced and asserted. The button state is used to determine if a

new “Action State” is desired. This simple state machine then decodes the desired

action. Once the desired command has been determined, a subroutine that performs

the desired command is executed. The low-voltage commands are driven directly from

the PIC10F206 I/O, but the high-voltage commands require some additional hardware

to generate the required 8V signal.

When a high-voltage command is required, the PIC10F206’s unique OSCOUT feature

is utilized. The OSCOUT function allows the instruction clock to be driven on

GP2/OSCOUT under software control. A simple charge pump consisting of 2 – 0.01 µF

capacitors and a BAV99 dual diode is constructed as seen in Appendix

A.2 “Schematic”. When the OSCOUT is enabled, a 1 MHz clock drives the charge

pump that produces an 8.4V signal on the MCP401X/2X’s CS pin (assuming

VDD = 5.0V). Utilizing such a charge pump requires special attention to the timing of the

CS & U/D signals.

Refer to the comments in the 00066_MCP402XEV.ASM source code for more details

on the firmware’s operation. Refer to Appendix E. “00066_MCP402XEV.ASM Source

Code”.

MCP402XEV 데이터시트(PDF) 21 Page - Microchip Technology