L6924UTR datasheet(29/37 Pages) STMICROELECTRONICS

29 / 37 page

L6924U

Additional applications information

Doc ID 14716 Rev 2

29/37

Additional applications information

9.1

Selecting the input capacitor

In most applications, a 1 µF ceramic capacitor, placed close to the VIN and VINSN pins can

be used to filter the high frequency noise.

9.2

Selecting the output capacitor

Typically, a 4.7 µF ceramic capacitor placed close to the VOUT and VOUTSN pin is enough to

keep

voltage control loop stable. This ensures proper operation of battery absent detection

in removable battery pack applications.

9.3

Layout guidelines and demonstration board

The thermal loop keeps the device at a constant temperature of approximately 120 °C which

in turn, reduces ICHG. However, in order to maximize the current capability, it is important to

ensure a good thermal path. Therefore, the exposed pad must be properly soldered to the

board and connected to the other layer through thermal vias. The recommended copper

thickness of the layers is 70

μm or more.

The exposed pad must be electrically connected to GND. Figure 22 shows the thermal

image of the board with the power dissipation of 1 W. In this instance, the temperature of the

case is 89 °C, but the junction temperature of the device is given by the following equation:

Equation 25

Where the RthJA of the device mounted on board is 75 °C/W, the power dissipated is 1 W,

and the ambient temperature is 25 °C.

In this case the junction temperature is:

Equation 26

AMB

DISS

THJ

−

100

L6924UTR 데이터시트(PDF) 29 Page - STMicroelectronics