PCF8583 datasheet(11/37 Pages) PHILIPS

11 / 37 page

PCF8583

All information provided in this document is subject to legal disclaimers.

Product data sheet

Rev. 06 — 6 October 2010

11 of 37

NXP Semiconductors

PCF8583

Clock and calendar with 240 x 8-bit RAM

7.7 Timer

The timer (location 07h) is enabled by setting the control and status register to

XX0X X1XX. The timer counts up from 0 (or a programmed value) to 99. On overflow, the

timer resets to 0. The timer flag (LSB of control and status register) is set on overflow of

the timer. This flag must be reset by software. The inverted value of this flag can be

transferred to the external interrupt by setting bit 3 of the alarm control register.

Additionally, a timer alarm can be programmed by setting the timer alarm enable (bit 6 of

the alarm control register). When the value of the timer equals a pre-programmed value in

the alarm timer register (location 0Fh), the alarm flag is set (bit 1 of the control and status

by enabling the alarm interrupt (bit 6 of the alarm control register).

Resolution of the timer is programmed via the 3 LSBs of the alarm control register (see

Figure 12).

Fig 11. Selection of alarm weekdays

765

4321

MSB

LSB

013aaa375

memory location 0Eh (alarm_weekday/month)

weekday 0 enabled when set

weekday 1 enabled when set

weekday 2 enabled when set

weekday 3 enabled when set

weekday 4 enabled when set

weekday 5 enabled when set

weekday 6 enabled when set

not used

PCF8583 데이터시트(PDF) 11 Page - NXP Semiconductors