CS8412 datasheet(14/36 Pages) CIRRUS

14 / 36 page

CS4327

DS190F1

Grounding and Power Supply Decoupling

As with any high resolution converter, the CS4327

requires careful attention to power supply and

grounding arrangements to optimize performance.

Figure 1 shows the recommended power arrange-

ments with VA+ connected to a clean +5 volt sup-

ply. VD+ should be derived from VA+ through a

2 ohm resistor. VD+ should not be used to power

additional digital circuitry. All mode pins which re-

quire VD+ should be connected to pin 6 of the

CS4327. All mode pins which require DGND

should be connected to pin 5 of the CS4327. Pins 4

and 5, AGND and DGND, should be connected to-

gether at the CS4327. DGND for the CS4327

should not be confused with the ground for the dig-

ital section of the system. The CS4327 should be

positioned over the analog ground plane near the

digital / analog ground plane split. The analog and

digital ground planes must be connected elsewhere

in the system. The CS4327 evaluation board,

CDB4327, demonstrates this layout technique.

This technique minimizes digital noise and insures

proper power supply matching and sequencing.

Decoupling capacitors should be located as near to

the CS4327 as possible.

Performance Plots

The following collection of CS4327 measurement

plots were taken from the CDB4327 evaluation

board using the Audio Precision Dual Domain Sys-

tem One.

Figure 13 shows the frequency response at a

48 kHz sample rate. The response is flat to 20 kHz

±0.1 dB as specified.

Figure 14 shows THD+N versus signal amplitude

for a 1 kHz 20-bit dithered input signal. Notice that

the there is no increase in distortion as the signal

level decreases. This indicates very good low-level

linearity, one of the key benefits of delta-sigma

digital to analog conversion.

Figure 15 shows a 16k FFT of a 1 kHz full-scale in-

put signal. The signal has been filtered by a notch

filter within the System One to remove the funda-

mental component of the signal. This minimizes

the distortion created in the analyzer analog-to-dig-

ital converter. This technique is discussed by Audio

Precision in the 10th anniversary addition of AU-

DIO.TST.

Figure 16 shows a 16k FFT of a 1 kHz -20 dBFS in-

put signal. The signal has been filtered by a notch

filter within the System One to remove the funda-

mental component of the signal.

Figure 17 shows a 16k FFT of a 1 kHz -60 dBFS in-

put signal.

Figure 18 shows the fade-to-noise linearity. The in-

put signal is a dithered 20-bit 500 Hz sine wave

which fades from -60 to -120 dBFS. During the

fade, the output from the CS4327 is measured and

compared to the ideal level. Notice the very close

tracking of the output level to the ideal, even at low

level inputs. The gradual shift of the plot away

from zero at signals levels < -110 dB is caused by

the background noise starting to dominate the mea-

surement.

CS8412 데이터시트(PDF) 14 Page - Cirrus Logic

CS8412 데이터시트(HTML) 14 Page - Cirrus Logic

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36

데이터시트 다운로드

링크 URL