NICHIA STS-DA1-2673B <Cat.No.130531>

5

SOLDERING

• Recommended Hand Soldering Condition

Temperature

380°C Max

Soldering Time

5sec Max

* Hand soldering must not be performed more than once.

* Since the silicone used in the encapsulating resin frame is soft, do not press on the encapsulating resin frame or resin area.

Pressure can cause nicks, chip-outs, encapsulant delamination and deformation, and wire breaks, decreasing reliability.

* Repairing should not be done after the LEDs have been soldered.

It should be confirmed beforehand whether the characteristics of the LEDs will or will not be damaged by repairing.

* When soldering, do not apply stress to the LED while the LED is hot.

* When using a pick and place machine, choose an appropriate nozzle for this product. Using a pick-and-place nozzle

with a smaller diameter than the size of the LED's emitting surface will cause damage to the emitting surface

and may also cause the LED not to illuminate.

* When flux is used, it should be a halogen free flux. Ensure that the manufacturing process is not designed in a manner

where the flux will come in contact with the LEDs.