DS1813 datasheet(2/5 Pages) DALLAS

2 / 5 page

DS1813

2 of 5

OPERATION - POWER MONITOR

The DS1813 provides the functions of detecting out-of-tolerance power supply conditions and warning a

processor-based system of impending power failure. When VCC is detected as out-of-tolerance, the RST

signal is asserted. On power-up, RST is kept active for approximately 150

µs after the power supply has

reached the selected tolerance. This allows the power supply and microprocessor to stabilize before RST

is released.

OPERATION - PUSHBUTTON RESET

The DS1813 provides for a pushbutton switch for manual reset control. When the DS1813 is not in a reset

cycle, a pushbutton reset can be generated by pulling the RST pin low for at least 1 ms. When the

pushbutton is held low, the RESET is forced active low and will remain active low for about 150 ms after

the pushbutton is released. See Figure 2 for an application example and Figure 3 for the timing diagram.

BLOCK DIAGRAM (OPEN-DRAIN OUTPUT) Figure 1

APPLICATION EXAMPLE Figure 2

DS1813 데이터시트(PDF) 2 Page - Dallas Semiconductor