DS2252T datasheet(13/15 Pages) DALLAS

13 / 15 page

DS2252T

13 of 15

SERIAL PORT TIMING - MODE 0

NOTES:

1. All voltage referenced to ground.

2. SDI should be taken to a logic high when VCC=+5V, and to approximately 3V when VCC<3V.

3. SDI is deglitched to prevent accidental destruction. The pulse must be longer than tSPR to pass the

deglitcher, but SDI is not guaranteed unless it is longer than tSPA.

4. Maximum operating ICC is measured with all output pins disconnected; XTAL1 driven with tCLKR,

tCLKF=10 ns, VIL = 0.5V; XTAL2 disconnected; RST = PORT0 = VCC.

5. Idle mode IIDLE is measured with all output pins disconnected; XTAL1 driven with tCLKR, tCLKF= 10

ns, VIL = 0.5V; XTAL2 disconnected; PORT0 = VCC, RST = VSS.

6. Stop mode ISTOP is measured with all output pins disconnected; PORT0 = VCC; XTAL2 not

connected; RST = XTAL1 = VSS.

7. Pin capacitance is measured with a test frequency - 1 MHz, tA= 25°C.

8. Crystal start-up time is the time required to get the mass of the crystal into vibrational motion from

the time that power is first applied to the circuit until the first clock pulse is produced by the on-chip

oscillator. The user should check with the crystal vendor for a worst case specification on this time.

DS2252T 데이터시트(PDF) 13 Page - Dallas Semiconductor