ZSSC3016

Low Power 16 Bit Sensor Signal Conditioner IC

Data Sheet

December 7, 2011

© 2011 Zentrum Mikroelektronik Dresden AG — Rev. 1.00

All rights reserved. The material contained herein may not be reproduced, adapted, merged, translated, stored, or used without

the prior written consent of the copyright owner. The information furnished in this publication is subject to changes without notice.

21 of 44

Figure 3.2

Operational Flow Chart: Command Mode and Normal Mode.

3.4.

Command Interpretation

3.4.1.

SPI/I2C Commands

designated by the user memory page pointer. Because each of the four OTP memory pages cannot be rewritten

or erased, the memory page pointer must be incremented to the next OTP memory page in order to write to

memory again (see Table 3.1 for the command). After all four user-accessible OTP memory pages have been

used, further write operations are not possible and the “Memory Full” bit is returned as set in the status byte after

write operations (see section 3.5.1).

The SPI/I

the user memory is the same as its address. The command to read the 16-bit memory status of the data at an