EM78P458AP datasheet(35/76 Pages) EMC

35 / 76 page

EM78P458/459

OTP ROM

(a) Select A/D input channel ( ADAS2:ADAS0 );

(b) Select the proper gains by writing to the GCON register ( optional );

(d) Set the ADPD bit to 1 to begin sampling.

(3) Put “ENI” instruction, if the interrupt function is employed.

(4) Set the ADRUN bit to 1.

(5) Wait for either the interrupt flag to be set or the ADC interrupt to occur.

(6) Read ADDATA, the conversion data register.

(7) Clear the interrupt flag bit (ADIF).

(8) For next conversion, go to Step 1 or Step 2 as required. At least 2 Tct is required before next

acquisition starts.

<Note>: To obtain an accurate value, it is necessary to avoid any data transition on I/O pins during

AD conversion.

2. The Demonstration Programs

; To define the general registers

R_0 == 0

; Indirect addressing register

PSW == 3

; Status register

PORT5 == 5

PORT6 == 6

R_F== 0XF

; Interrupt status register

; To define the control register

IOC50 == 0X5

; Control Register of Port 5

IOC60 == 0X6

; Control Register of Port 6

C_INT== 0XF

; Interrupt Control Register

;ADC Control Registers

ADDATA == 0xA

; The contents are the results of ADC

ADCON R== 0x9

; 7

This specification is subject to change without prior notice.

06.25.2004 (V1.4)

EM78P458AP 데이터시트(PDF) 35 Page - ELAN Microelectronics Corp