EM78P459AM datasheet(30/76 Pages) EMC

30 / 76 page

EM78P458/459

OTP ROM

4.6 Interrupt

The EM78P458/459 has six interrupts as listed below:

(1) TCC overflow interrupt

(2) Port 6 Input Status Change Interrupt

(3) External interrupt [(P50, /INT) pin].

(4) Analog to Digital conversion completed.

(5) When TMR1/TMR2 matches with PRD1/PRD2 respectively in PWM.

(6) When the comparators output change.

Before the Port 6 Input Status Change Interrupt is enabled, reading Port 6 (e.g. "MOV R6,R6") is

necessary. Each Port 6 pin will have this feature if its status changes. Any pin configured as output or

P50 pin configured as /INT, is excluded from this function. Port 6 Input Status Change Interrupt will

wake up the EM78P458/459 from the sleep mode if it is enabled prior to going into the sleep mode by

executing SLEP. When the controller is wake-up, it will continue to execute the succeeding program if

the global interrupt is disabled, or branches out to the interrupt vector 008H if the global interrupt is

enabled.

RF, the interrupt status register that records the interrupt requests in the relative flags/bits. IOCF0 is

an interrupt mask register. The global interrupt is enabled by the ENI instruction and is disabled by the

DISI instruction. When one of the interrupts (when enabled) occurs, the next instruction will be

fetched from address 008H. Once in the interrupt service routine, the source of an interrupt can be

determined by polling the flag bits in RF. The interrupt flag bit must be cleared by instructions before

leaving the interrupt service routine to avoid recursive interrupts.

The flag (except ICIF bit) in the Interrupt Status Register (RF) is set regardless of the status of its

mask bit or the execution of ENI. Note that the outcome of RF will be the logic AND of RF and IOCF0

(refer to Fig. 11). The RETI instruction ends the interrupt routine and enables the global interrupt (the

execution of ENI).

When an interrupt is generated by the INT instruction (when enabled), the next instruction will be

fetched from address 001H.

This specification is subject to change without prior notice.

06.25.2004 (V1.4)

EM78P459AM 데이터시트(PDF) 30 Page - ELAN Microelectronics Corp