FEDL2280XFULL-04

ML22808/ML22804/Ml22802-XXX

8.

SLOOP command

• command

1

0

0

0

⎯

⎯

⎯

⎯

The SLOOP command is used to set repeat playback mode.

The CLOOP command is used to release repeat

playback mode.

Since the SLOOP command is valid only during playback, be sure to input the SLOOP command while the NCR

signal is at a “H” level after the PLAY command is input.

The NCR signal remains “L” during repeat playback

mode.

Once repeat playback mode is set, the current phrase is repeatedly played back until the repeat playback setting

is released by SLOOP command or until playback is stopped by the STOP command.

In the case of a phrase

using the edit function, the edited phrase is repeatedly played back.

Since repeat playback mode is released when playback is stopped by the STOP command, input the SLOOP

command once again if desired to repeat the playback.

Following shows the SLOOP command input timing.

CS

Status

SCK

DI

NCR

BUSY

AOUT

1V

PLAY command

2

SLOOP command

CLOOP command

Awaiting command

Playing

Address is being controlled

Address is being controlled

Playing

Awaiting command

Command is being processed

Effective Range of SLOOP Command Input

After the PLAY command is input, input the SLOOP command within 10 ms (tcm) after NCR goes “H”.

This

will enable the SLOOP command, so that repeat playback will be carried out.

34/41