HCPL-2602 datasheet(12/20 Pages) HP

12 / 20 page

Package Characteristics

All Typicals at TA = 25°C.

Parameter

Sym.

Package

Min.

Typ.

Max.

Units

Test Conditions

Fig.

Note

Input-Output

II-O*

Single 8-Pin DIP

µA

45% RH, t = 5 s,

20, 21

Insulation

Single SO-8

VI-O = 3 kV dc, TA = 25°C

Input-Output

VISO

8-Pin DIP, SO-8

3750

V rms

≤ 50%, t = 1 min,

20, 21

Momentary With-

Widebody

5000

TA = 25°C

20, 22

stand Voltage**

OPT 020†

5000

Input-Output

RI-O

8-Pin DIP, SO-8

1012

Ω

VI-O = 500 V dc

1, 20,

Resistance

Widebody

1012

1013

TA = 25°C23

1011

TA = 100°C

Input-Output

CI-O

8-Pin DIP, SO-8

0.6

f = 1 MHz, TA = 25°C

1, 20,

Capacitance

Widebody

0.5

0.6

Input-Input

II-I

Dual Channel

0.005

µA

≤ 45%, t = 5 s,

Insulation

VI-I = 500 V

Leakage Current

Resistance

RI-I

Dual Channel

1011

Ω

(Input-Input)

Capacitance

CI-I

Dual 8-Pin DIP

0.03

f = 1 MHz

(Input-Input)

Dual SO-8

0.25

*JEDEC registered data for the 6N137. The JEDEC Registration specifies 0

°C to 70°C. Agilent specifies -40°C to 85°C.

**The Input-Output Momentary Withstand Voltage is a dielectric voltage rating that should not be interpreted as an input-output

continuous voltage rating. For the continuous voltage rating refer to the IEC/EN/DIN EN 60747-5-2 Insulation Characteristics Table

(if applicable), your equipment level safety specification or Agilent Application Note 1074 entitled “Optocoupler Input-Output

Endurance Voltage.”

†For 6N137, HCPL-2601/2611/2630/2631/4661 only.

Notes:

1. Each channel.

2. Peaking circuits may produce transient input currents up to 50 mA, 50 ns maximum pulse width, provided average current does

not exceed 20 mA.

3. Peaking circuits may produce transient input currents up to 50 mA, 50 ns maximum pulse width, provided average current does

not exceed 15 mA.

4. Derate linearly above 80

°C free-air temperature at a rate of 2.7 mW/°C for the SOIC-8 package.

5. Bypassing of the power supply line is required, with a 0.1

µF ceramic disc capacitor adjacent to each optocoupler as illustrated in

Figure 17. Total lead length between both ends of the capacitor and the isolator pins should not exceed 20 mm.

6. The JEDEC registration for the 6N137 specifies a maximum IOH of 250 µA. Agilent guarantees a maximum IOH of 100 µA.

7. The JEDEC registration for the 6N137 specifies a maximum ICCH of 15 mA. Agilent guarantees a maximum ICCH of 10 mA.

8. The JEDEC registration for the 6N137 specifies a maximum ICCL of 18 mA. Agilent guarantees a maximum ICCL of 13 mA.

9. The JEDEC registration for the 6N137 specifies a maximum IEL of –2.0 mA. Agilent guarantees a maximum IEL of -1.6 mA.

10. The tPLH propagation delay is measured from the 3.75 mA point on the falling edge of the input pulse to the 1.5 V point on the

rising edge of the output pulse.

11. The tPHL propagation delay is measured from the 3.75 mA point on the rising edge of the input pulse to the 1.5 V point on the

falling edge of the output pulse.

12. tPSK is equal to the worst case difference in tPHL and/or tPLH that will be seen between units at any given temperature and specified

test conditions.

13. See application section titled “Propagation Delay, Pulse-Width Distortion and Propagation Delay Skew” for more information.

14. The tELH enable propagation delay is measured from the 1.5 V point on the falling edge of the enable input pulse to the 1.5 V

point on the rising edge of the output pulse.

15. The tEHL enable propagation delay is measured from the 1.5 V point on the rising edge of the enable input pulse to the 1.5 V point

on the falling edge of the output pulse.

16. CMH is the maximum tolerable rate of rise of the common mode voltage to assure that the output will remain in a high logic state

(i.e., VO > 2.0 V).

17. CML is the maximum tolerable rate of fall of the common mode voltage to assure that the output will remain in a low logic state

(i.e., VO < 0.8 V).

18. For sinusoidal voltages, (|dVCM | / dt)max = π fCMVCM(p-p).

HCPL-2602 데이터시트(PDF) 12 Page - Agilent(Hewlett-Packard)

HCPL-2602 데이터시트(HTML) 12 Page - Agilent(Hewlett-Packard)

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20

데이터시트 다운로드

링크 URL