A7985ATR datasheet(14/44 Pages) STMICROELECTRONICS

14 / 44 page

Functional description

A7985A

14/44

DocID023128 Rev 5

5.3

Error amplifier and compensation

The error amplifier (E/A) provides the error signal to be compared with the sawtooth to

perform the pulse width modulation. Its non inverting input is internally connected to a 0.6 V

voltage reference, while its inverting input (FB) and output (COMP) are externally available

for feedback and frequency compensation. In this device the error amplifier is a voltage

mode operational amplifier, so with high DC gain and low output impedance.

The uncompensated error amplifier characteristics are shown in Table 5.

In continuous conduction mode (CCM), the transfer function of the power section has two

poles due to the LC filter and one zero due to the ESR of the output capacitor. Different

kinds of compensation networks can be used depending on the ESR value of the output

capacitor. In case the zero introduced by the output capacitor helps to compensate the

double pole of the LC filter, a Type II compensation network can be used. Otherwise, a Type

III compensation network must be used (see Section 6.4 on page 20 for details of the

compensation network selection).

The methodology to compensate the loop is to introduce zeroes to obtain a safe phase

margin.

5.4

Overcurrent protection

The A7985A implements the overcurrent protection sensing current flowing through the

Power MOSFET. Due to the noise created by the switching activity of the Power MOSFET,

the current sensing is disabled during the initial phase of the conduction time. This avoids

an erroneous detection of a fault condition. This interval is generally known as “masking

time” or “blanking time”. The masking time is about 200 ns.

If the overcurrent limit is reached, the Power MOSFET is turned off, implementing the pulse-

by-pulse overcurrent protection. Under an overcurrent condition, the device can skip turn-on

pulses in order to keep the output current constant and equal to the current limit. If, at the

end of the “masking time”, the current is higher than the overcurrent threshold, the Power

MOSFET is turned off and one pulse is skipped. If, at the following switching-on, when the

“masking time” ends, the current is still higher than the overcurrent threshold, the device

skips two pulses. This mechanism is repeated and the device can skip up to seven pulses.

While, if at the end of the “masking time” the current is lower than the over current threshold,

the number of skipped cycles is decreased by one unit (see Figure 8).

So the overcurrent/short-circuit protection acts by switching off the Power MOSFET and

reducing the switching frequency down to one eighth of the default switching frequency, in

order to keep constant the output current around the current limit.

Table 5. Uncompensated error amplifier characteristics

Parameter

Value

Low frequency gain

100 dB

GBWP

4.5 MHz

Slew rate

7 V/

s

Output voltage swing

0 to 3.3 V

Maximum source/sink current

17 mA/25 mA

A7985ATR 데이터시트(PDF) 14 Page - STMicroelectronics

A7985ATR 데이터시트(HTML) 14 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44

데이터시트 다운로드

링크 URL