GMS97C2051 datasheet(10/39 Pages) HYNIX

10 / 39 page

GMS97C2051/L2051

8-Bit CMOS Microcontroller

HYUNDAI MicroElectronics

Idle Mode

In idle mode, the CPU puts itself to sleep while all the

on-chip peripherals remain active.

The mode is in-

voked by software.

The content of the on-chip RAM

and all the special functions registers remain unchanged

during this mode.

The idle mode can be terminated by

any enabled interrupt or by a hardware reset.

P1.0 and

P1.1 should be set to ‘0’ if no external pullups are used,

or set to ‘1’ if external pullups are used.

It should be noted that when idle is terminated by a

hardware reset, the device normally resumes program

execution, from where it left off, up to two machine

cycles before the internal reset algorithm takes control.

On-chip hardware inhibits access to internal RAM in

this event, but access to the port pins is not inhibited.

To eliminate the possibility of an unexpected write to a

port pin when Idle is terminated by reset, the instruc-

tion following one that invokes Idle should not be one

that writes to a port pin or to external memory.

Power Down Mode

GMS97C2051/L2051 have two power saving modes,

Idle and Power Down.

The bits PD and IDLE of the

Idle mode, respectively.

If 1s are written to PD and

IDLE at the same time, PD takes precedence.

Table 9

gives a general overview of the Power saving modes. In

the Power Down mode of operation, VCC can be re-

duced to minimize power consumption.

It must be

ensured, however, that Vcc is not reduced before the

Power Down mode is invoked, and that Vcc is restored

to its normal operating level, before the Power Down

mode is terminated.

The reset signal that terminates

the Power down mode also restarts the oscillator.

The

reset should not be activated before Vcc is restored to

its normal operating level and must be held active long

enough to allow the oscillator to restart and stabilize.

( similar to power-on reset ).

Table 9. Power Saving Modes Overview

Mode

Ex. instruction to enter

To terminate

Remarks

Idle mode

ORL PCON, #01H

Enabled interrupt,

Hardware Reset

- CPU is gated off

- CPU status registers maintain their data.

- Peripherals are active

Power-down Mode

ORL PCON, #02H

Hardware Reset

- Oscillator stops

- Contents of on-chip RAM and SFRs are

maintained

- Reset redefines all the SFRs but does not

change the on-chip RAM

GMS97C2051 데이터시트(PDF) 10 Page - Hynix Semiconductor

GMS97C2051 데이터시트(HTML) 10 Page - Hynix Semiconductor

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39

데이터시트 다운로드

링크 URL