7

ICS9342

Third party brands and names are the property of their respective owners.

Fig. 1

Shared Pin Operation -

Input/Output Pins

The I/O pins designated by (input/output) on the ICS9342

serve as dual signal functions to the device. During initial

power-up, they act as input pins. The logic level (voltage)

that is present on these pins at this time is read and stored

into a 5-bit internal data latch. At the end of Power-On reset,

(see AC characteristics for timing values), the device changes

the mode of operations for these pins to an output function.

In this mode the pins produce the specified buffered clocks

to external loads.

To program (load) the internal configuration register for

these pins, a resistor is connected to either the VDD (logic 1)

power supply or the GND (logic 0) voltage potential. A 10

Kilohm (10K) resistor is used to provide both the solid

CMOS programming voltage needed during the power-up

programming period and to provide an insignificant load on

the output clock during the subsequent operating period.

Via to

VDD

Clock trace to load

Series Term. Res.

Programming

Header

Via to Gnd

Device

Pad

2K

W

8.2K

W

Figure 1 shows a means of implementing this function

when a switch or 2 pin header is used. With no jumper is

installed the pin will be pulled high. With the jumper in

place the pin will be pulled low. If programmability is not

necessary, than only a single resistor is necessary. The

programming resistors should be located close to the series

termination resistor to minimize the current loop area. It is

more important to locate the series termination resistor

close to the driver than the programming resistor.