| 전자부품 데이터시트 검색엔진 |
|
82802AC 데이터시트(PDF) 25 Page - Intel Corporation |
|
|
|||||||||||||||||||||||||||||
82802AC 데이터시트(HTML) 25 Page - Intel Corporation |
|
25 / 53 page ![]() Intel ® 82802AB/AC Firmware Hub R Datasheet 25 4.9.1. T_BLOCK_LK and T_MINUSxx_LK — Block-Locking Registers Memory Address: FFBx0002h (x = F-0h) Default Value: 01h Access: R/W Size: 8 bits (each) Bit Function 7:3 Reserved 2 Read-Lock 1 = Prevents read operations in the block where set. 0 = Normal operation for reads in the block where clear. This is the default state. 1 Lock-Down 1 = Prevents further set or clear operations to the Write Lock and Read Lock bits. Lock-Down only can be set, but not cleared. The block will remain locked-down until reset (with RST# or INIT#), or until the device is power-cycled. 0 = Normal operation for Write Lock and Read Lock bit altering in the block where clear. This is the default state. 0 Write-Lock 1 = Prevents program or erase operations in the block where set. This is the default state. 0 = Normal operation for programming and erase in the block where clear. Table 6. Register-Based Locking Value Definitions Data Reserved Data 7:3 Read Lock, Data 2 Lock-Down, Data 1 Write Lock, Data 0 Resulting block state (1). 00h 00000 0 0 0 Full access 01h 00000 0 0 1 Write locked. Default state at power- up 02h 00000 0 1 0 Locked open (full access locked down). 03h 00000 0 1 1 Write-locked down. 04h 00000 1 0 0 Read locked. 05h 00000 1 0 1 Read and write locked. 06h 00000 1 1 0 Read-locked down. 07h 00000 1 1 1 Read- and write-locked down. Note: The write-lock bit must be set to the desired protection state prior to starting a program or erase operation, since it is sampled at the beginning of the operation. Changing the state of the write-lock bit during a program or erase operation may cause unpredictable results. If the state of the write-lock bit changes during a program suspend or erase suspend state, changes in the block’s locking status do not occur immediately. The suspended operation may be resumed successfully. The new lock status will take place after the program or erase operation completes. The individual bit functions are described in the following sections. |
|
링크 URL |
| ALLDATASHEET 가 귀하에 도움이 되셨나요? [ DONATE ] |
Alldatasheet는? | 광고문의 | 운영자에게 연락하기 | 개인정보취급방침 | 링크 투 데이터시트 | 링크교환 | 제조사별 검색 All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |