SNMPWEBCARD), or the monitoring of any number of additional UPS systems over IP with included PowerAlert monitoring software.

Communications ports support messaging of UPS and line power status, including on-battery, low-battery, power restored, AC line voltage, DC battery

voltage and remaining battery capacity

Supports timed inverter shutoff after unattended shutdown, activate self-test and UPS output power control for delayed or immediate reboot of connected

equipment

Supports Tripp Lite's WatchDog software application to restore unresponsive programs by systematically restarting applications, operating systems and

ultimately rebooting completely locked computers by momentarily switching UPS power off and back on again (requires optional WATCHDOGSW)

Status LEDs offer continuous status information of UPS operating parameters and site power quality

Hot-swappable batteries allow on-site battery replacement without powering off connected equipment

Single line TEL/DSL and network Ethernet line surge suppression

Specifications

OUTPUT

Output Volt Amp Capacity (VA)

750

Output Watt Capacity (Watts)

500

Power Factor

0.7

Nominal Output Voltage(s)

Supported

100V; 110V; 120V

Nominal Voltage Details

120V default (voltage selection via back panel switches)

Frequency Compatibility

50 / 60 Hz

Output Voltage Regulation (Line

Mode)

-13%, +15%

Output Voltage Regulation (Battery

Mode)

+/- 5%

Output Receptacles

(8) 5-15R

UPS Output Receptacles (Surge

Suppression Only)

4 UPS outlets, 4 surge-only outlets

Output AC Waveform (AC Mode)

Sine wave

Output AC Waveform (Battery Mode)

Pure Sine wave

INPUT

Rated input current (Maximum Load)

12A

Nominal Input Voltage(s) Supported

100V AC; 110V AC; 120V AC

UPS Input Connection Type

5-15P

UPS Input Cord Length (ft.)

6

UPS Input Cord Length (m)

1.8

Recommended Electrical Service

15A 120V

Input Phase

Single-Phase

2 / 5