AN2728

Demonstration board usage recommendation

13/20

4

Demonstration board usage recommendation

The demonstration board shown in Figure 11 is provided with Kelvin connection, which

means that two lines are available for each pin. One used for supplying or sinking current

measurement.

The board has one enable pin available which is located on the right side of the board. This

pin can be used to supply the enable pin with a external voltage higher than 1.5 V to turn on

or lower than 0.5 V to turn off the device.

Figure 11.

ST1S12 demonstration board layout

Figure 12.

Demonstration board layers

Bottom layer

Top layer