PM0214 datasheet(116/245 Pages) STMICROELECTRONICS

116 / 245 page

The STM32 Cortex-M4 instruction set

PM0214

116/245

DocID022708 Rev 4

3.6.6

SMLSD and SMLSLD

Signed multiply subtract dual and Signed multiply subtract long dual

Syntax

op{X}{cond} Rd, Rn, Rm, Ra

where:

•

op is one of:

SMLSD: Signed multiply subtract dual.

SMLSDX: Signed multiply subtract dual reversed

SMLSLD: Signed multiply subtract long dual.

SMLSLDX: Signed multiply subtract long dual reversed.

–

If X is present, the multiplications are bottom × top and top × bottom.

–

If the X is omitted, the multiplications are bottom × bottom and top × top.

•

‘cond’ is an optional condition code (see Conditional execution on page 64)

•

‘Rd’ is the destination register.

•

‘Rn’, ‘Rm’ are registers holding the first and second operands

•

‘Ra’ is the register holding the accumulate value

Operation

The SMLSD instruction interprets the values from the first and second operands as four

signed halfwords. This instruction:

Optionally rotates the halfwords of the second operand.

Performs two signed 16 × 16-bit halfword multiplications.

Subtracts the result of the upper halfword multiplication from the result of the lower

halfword multiplication.

Adds the signed accumulate value to the result of the subtraction.

Writes the result of the addition to the destination register.

The SMLSLD instruction interprets the values from Rn and Rm as four signed halfwords.

This instruction:

Optionally rotates the halfwords of the second operand.

Performs two signed 16 × 16-bit halfword multiplications.

Subtracts the result of the upper halfword multiplication from the result of the lower

halfword multiplication.

Adds the 64-bit value in RdHi and RdLo to the result of the subtraction.

Writes the 64-bit result of the addition to the RdHi and RdLo.

Restrictions

In these instructions: Do not use SP or PC.

Condition flags

This instruction sets the Q flag if the accumulate operation overflows. Overflow cannot occur

during the multiplications or subtraction.

For the Thumb instruction set, these instructions do not affect the condition code flags.

Examples

PM0214 데이터시트(PDF) 116 Page - STMicroelectronics

PM0214 데이터시트(HTML) 116 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

데이터시트 다운로드

링크 URL