LTC3203 datasheet(6/16 Pages) LINER

6 / 16 page

LTC3203/LTC3203-1

LTC3203B/LTC3203B-1

32031fa

PI FU CTIO S

C2+ (Pin 1): Flying Capacitor 2 Positive Terminal (C2).

VOUT (Pin 2): Regulated Output Voltage. VOUT should be

bypassed with a low ESR ceramic capacitor as close to the

pin as possible for best performance. The capacitor should

have greater than 4.7

µF capacitance under all conditions.

C1+ (Pin 3): Flying Capacitor 1 Positive Terminal (C1).

SHDN (Pin 4): Active Low Shutdown Input. A low on SHDN

puts the LTC3203/LTC3203-1/LTC3203B/LTC3203B-1 in

low current shutdown mode. Do not float the SHDN pin.

VSEL (Pin 5) (LTC3203-1/LTC3203B-1): Output Voltage

Selection Input. A logic 0 at VSEL sets the regulated VOUT

to 4.5V; and a logic 1 sets the regulated VOUT to 5V. Do not

float the VSEL pin.

FB (Pin 5) (LTC3203/LTC3203B): Feedback. The voltage

on this pin is compared to the internal reference voltage

(0.91V) by the error amplifier to keep the output in

regulation. An external resistor divider is required

between VOUT and FB to program the output voltage.

MODE (Pin 6): Mode Selection Input. The LTC3203/

LTC3203-1/LTC3203B/LTC3203B-1 operates in 1.5x

mode if the MODE pin is greater than VMODEH, which

gives higher charge pump efficiency. If the MODE pin is

less than VMODEL, the LTC3203/LTC3203-1/LTC3203B/

LTC3203B-1 operates in 2x mode, which gives a higher

charge pump boost voltage.

VIN (Pin 7): Input Supply Voltage. VIN should be bypassed

with a more than 2.2

µF low ESR ceramic capacitor to GND.

C2– (Pin 8): Flying Capacitor 2 Negative Terminal (C2).

GND (Pin 9): Ground. This pin should be connected

directly to a low impedance ground plane.

C1– (Pin 10): Flying Capacitor 1 Negative Terminal (C1).

Exposed Pad (Pin 11): Ground. This pin must be sol-

dered to the PCB for electrical contact and rated thermal

performance.

LTC3203 데이터시트(PDF) 6 Page - Linear Technology