UM1547 datasheet(17/51 Pages) STMICROELECTRONICS

17 / 51 page

DocID023232 Rev 5

17/51

UM1547

AT command list

3.13

DeleteSmartCable

The DeleteSmartCable command removes the current Smart Cable settings that were

entered using the SmartCableSetup command, but not the setting from the dynamic

configuration. The Smart Cable will then be deactivated for the remainder of this session.

Upon reset, if a dynamic configuration for a Smart Cable exists, it will be activated. If there is

no dynamic configuration Smart Cable setup, then this feature will remain deactivated.

3.13.1

Syntax

AT+AB DeleteSmartCable

3.13.2

Responses

If the operation is successful, the response is:

AT-AB DeleteSmartCableDone

3.14

DisableBond

The DisableBond command is used to deny new bonding with a device.

This command cannot be used while a connection is active.

3.14.1

Syntax

AT+AB DisableBond

3.14.2

Responses

If the operation is successful, the response is:

AT-AB BondDisabled

3.15

Discovery

The discovery command is used to initiate a device discovery. The command will return the

number of responses of nearby devices and then the individual responses with BD address

and name of device. The number of devices returned is limited to 10.

Inquiry is performed with an interval of 10.24 seconds.

The devices are reported in the same order as the original inquiry results.

3.15.1

Syntax

AT+AB Discovery [COD filters]

UM1547 데이터시트(PDF) 17 Page - STMicroelectronics