3

RH119

Information furnished by Linear Technology Corporation is believed to be accurate and reliable.

However, no responsibility is assumed for its use. Linear Technology Corporation makes no represen-

tation that the interconnection of its circuits as described herein will not infringe on existing patent rights.

Note 1: For supply voltages less than ± 15V, the maximum input voltage is

equal to the supply voltage.

25°C. The GND pin is grounded. Note that the maximum voltage allowed

the power supply voltage exceeds ± 9V. The offset voltage, offset current

and bias current specifications apply for all supply voltages between ± 15V

and 5V unless otherwise specified.

Note 3: The offset voltages and currents given are the maximum values

required to drive the output within 1V of either supply with a 1mA load––

thus, these parameters define an error band and take into account the

worst-case effects of voltage gain and input impedance.

Note 4: Response time specified for a 100mV input step with 5mV

overdrive.

MIL-STD-883 TEST REQUIREMENTS

SUBGROUP

Final Electrical Test Requirements (Method 5004)

1*,2,3,4

Group A Test Requirements (Method 5005)

1,2,3,4

Group C and D End Point Electrical Parameters

1

(Method 5005)

* PDA Applies to subgroup 1. See PDA Test Notes.

PDA Test Notes

The PDA is specified as 5% based on failures from group A, subgroup 1,

tests after cooldown as the final electrical test in accordance with method

5004 of MIL-STD-883 Class B. The verified failures (including Delta

parameters) of group A, subgroup 1, after burn-in divided by the total

number of devices submitted for burn-in in that lot shall be used to

determine the percent for the lot.

Linear Technology Corporation reserves the right to test to tighter limits

than those given.

TABLE 2: ELECTRICAL TEST REQUIRE E TS

TOTAL DOSE BIAS CIRCUIT

–

+

–

+

15V

SIDE 1

SIDE 2

100

Ω

10k

10k

10k

10k

GND1

GND2

OUT1

OUT2

–15V

RH119 TDBC