RH137 datasheet(3/4 Pages) LINER

3 / 4 page

RH137

Information furnished by Linear Technology Corporation is believed to be accurate and reliable.

However, no responsibility is assumed for its use. Linear Technology Corporation makes no represen-

tation that the interconnection of its circuits as described herein will not infringe on existing patent rights.

50KRAD(Si)

20KRAD(Si)

10KRAD(Si)

100KRAD(Si)

200KRAD(Si)

SYMBOL PARAMETER

CONDITIONS

NOTES MIN

MAX

MIN

MAX

MIN

MAX

MIN

MAX

MIN

MAX

UNITS

IADJ

Adjust Pin Current

100

µA

I ADJ

Adjust Pin Current Change

10mA I OUT I MAX

µA

VIN – VOUT= 40V

µA

IMIN

Minimum Load Current

VIN – VOUT= 40V

VIN – VOUT 10V

Current Limit

H Package

VIN – VOUT 15V

0.5

1.5

0.5

1.5

0.5

1.5

0.5

1.5

0.5

1.5

VIN – VOUT= 40V

0.15

0.5

0.15

0.5

0.15

0.5

0.15

0.5

0.15

0.5

K Package

VIN – VOUT 15V

1.5

3.2

1.5

3.2

1.5

3.2

1.5

3.2

1.5

3.2

VIN – VOUT= 40V

0.24

TABLE 1A: ELECTRICAL CHARACTERISTICS (Postirradiation) (Note 4)

Note 1: Unless otherwise specified, these specifications apply for

VIN – VOUT= 5V; and IOUT = 0.1A for the H package (TO-39) and

IOUT = 0.5A for the K package (TO-3) package. Although power dissipation

is internally limited, these specifications are applicable for power

dissipations of 2W for the TO-39 and 20W for the TO-3. IMAX is 0.2A for

the TO-39 and 1.5A for the TO-3 package.

Note 2: Regulation is measured at a constant junction temperature using

pulse testing with a low duty cycle. Changes in output voltage due to

heating effects are covered under the specification for thermal regulation.

Note 3: Guaranteed by design, characterization or correlation to other

tested parameters.

Note 4: TJ = 25°C unless otherwise noted.

MIL-STD-883 TEST REQUIREMENTS

SUBGROUP

Final Electrical Test Requirements (Method 5004)

1*,2,3

Group A Test Requirements (Method 5005)

1,2,3

Group C and D End Point Electrical Parameters

(Method 5005)

* PDA Applies to subgroup 1. See PDA Test Notes.

PDA Test Notes

The PDA is specified as 5% based on failures from group A, subgroup 1,

tests after cooldown as the final electrical test in accordance with method

5004 of MIL-STD-883 Class B. The verified failures of group A, subgroup

1, after burn-in divided by the total number of devices submitted for burn-

in in that lot shall be used to determine the percent for the lot.

Linear Technology Corporation reserves the right to test to tighter limits

than those given.

TABLE 2: ELECTRICAL TEST REQUIRE E TS

TOTAL DOSE BIAS CIRCUIT

RH137

VIN

243

Ω

ADJ

–15V

RH137 TDBC

OUTPUT

CASE

RH137 데이터시트(PDF) 3 Page - Linear Technology

RH137 데이터시트(HTML) 3 Page - Linear Technology

Html Pages

1 2 3 4

데이터시트 다운로드

링크 URL