RF2861 datasheet(13/15 Pages) RFMD

13 / 15 page

13 of 15

RF2861

DS120220

7628 Thorndike Road, Greensboro, NC 27409-9421 · For sales or technical

support, contact RFMD at (+1) 336-678-5570 or customerservice@rfmd.com.

IF Output Interface Network

Single-End IF Matching

L1, C1, C2, and R form a current combiner which performs a differential to single-ended conversion at the IF frequency and

sets the output impedance. In most cases, the resonance frequency is independent of R and can be set according to the fol-

lowing equation:

Where CEQ is the equivalent stray capacitance and capacitance looking into pins 9 and 10. An average value to use for CEQ is

2.5pF.

R can then be used to set the output impedance according to the following equation:

where ROUT is the desired output impedance and RP is the parasitic equivalent parallel resistance of L1.

C2 should first be set to 0 and C1 should be chosen as high as possible (not greater than 39pF), while maintaining an RP of L1

that allows for the desired ROUT. If the self-resonant frequencies of the selected C1 produce unsatisfactory linearity perfor-

mance, their values may be reduced and compensated for by including C2 capacitor with a value chosen to maintain the

desired FIF frequency.

L2 and C3 serve dual purposes. L2 serves as an output bias choke, and C3 serves as a series DC block.

In addition, L2 and C3 may be chosen to form an impedance matching network if the input impedance of the IF filter is not

equal to ROUT. Otherwise, L2 is chosen to be large (suggested 120nH) and C3 is chosen to be large (suggested 22nF) if a DC

path to ground is present in the IF filter, or omitted if the filter is DC-blocked.

IF-

IF+

VCC

33 nF

IF Saw

IF+

IF-

------ C





-----------------------------------------------------------

4 R

OUT



---------------------

------

–



 1

–

RF2861 데이터시트(PDF) 13 Page - RF Micro Devices

RF2861 데이터시트(HTML) 13 Page - RF Micro Devices

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15

데이터시트 다운로드

링크 URL