LP6229 datasheet(5/6 Pages) POWER

5 / 6 page

Preliminary Datasheet

LP6229

LP6229 –00 Version 1.0 Datasheet

Jul.-2013

www.lowpowersemi.com - -

Page 5 of 6

Input Capacitor Selection

For better input bypassing, low-ESR ceramic

capacitors are recommended for performance. A

10μF input capacitor is sufficient for most

applications. For a lower output power requirement

application, this value can be decreased.

Output Capacitor Selection

For lower output voltage ripple, low-ESR ceramic

capacitors

are

recommended.

The

tantalum

capacitors can be used as well, but the ESR is

bigger than ceramic capacitor. The output voltage

ripple consists of two components: one is the

pulsating output ripple current flows through the

ESR, and the other is the capacitive ripple caused by

charging and discharging.

Layout Guideline

For high frequency switching power supplies, the

PCB layout is important step in system application

design. In order to let IC achieve good regulation,

high efficiency and stability, it is strongly

recommended the power components should be

placed as close as possible. The set races should be

wide and short. The feedback pin and then works of

feedback and compensation should keep away from

the power loops, and be shielded with a ground

trace or plane to prevent noise coupling.

LP6229 데이터시트(PDF) 5 Page - Lowpower Semiconductor inc