©2015 Glenair, Inc.

REV: 3

US Cage Code 06324

Printed in USA

GLENAIR, INC.

∙ 1211 AIR WAY ∙ GLENDALE, CA 91201-2497

∙ TEL: 818-247-6000

∙ FAX: 818-500-9912

www.glenair.com

PAGE 10 of 15

E-mail: sales@glenair.com

050-320 Product Brief

PCB Mount Dual Receiver for Single Mode Fiber

100 Mbps – 4.25 Gbps, 3.3V

Required Host Board Components

A power supply noise rejection filter as describe in SFP MSA is required on the host PCB to meet data sheet

performance. This is filter incorporates an inductor which should be rated to

400 mADC and 1 Ω series resistance or

better. It should not be replaced with a ferrite. The required filter is illustrated in Figure 5. Also, the host PCB for the PCB

mount Dual-Receiver

requires 4.7 K to 10 KΩ pull-up resistors for TX_FAULT, LOS, SCA and SDL lines.

Fiber Compatibility

The Dual-Receiver is capable of transmission at 2 to 10km with 9

/125 μm fiber.