PIC876 datasheet(70/218 Pages) MICROCHIP

70 / 218 page

PIC16F87X

DS30292C-page 68

 2001 Microchip Technology Inc.

SSPCON2: SYNC SERIAL PORT CONTROL REGISTER2 (ADDRESS 91h)

R/W-0

GCEN

ACKSTAT

ACKDT

ACKEN

RCEN

PEN

RSEN

SEN

bit 7

bit 0

bit 7

GCEN: General Call Enable bit (In I2C Slave mode only)

= Enable interrupt when a general call address (0000h) is received in the SSPSR

= General call address disabled

bit 6

ACKSTAT: Acknowledge Status bit (In I2C Master mode only)

In Master Transmit mode:

= Acknowledge was not received from slave

= Acknowledge was received from slave

bit 5

ACKDT: Acknowledge Data bit (In I2C Master mode only)

In Master Receive mode:

Value that will be transmitted when the user initiates an Acknowledge sequence at the

end of a receive.

= Not Acknowledge

= Acknowledge

bit 4

ACKEN: Acknowledge Sequence Enable bit (In I2C Master mode only)

In Master Receive mode:

= Initiate Acknowledge sequence on SDA and SCL pins and transmit ACKDT data bit.

Automatically cleared by hardware.

= Acknowledge sequence idle

bit 3

RCEN: Receive Enable bit (In I2C Master mode only)

= Enables Receive mode for I2C

= Receive idle

bit 2

PEN: STOP Condition Enable bit (In I2C Master mode only)

SCK Release Control:

= Initiate STOP condition on SDA and SCL pins. Automatically cleared by hardware.

= STOP condition idle

bit 1

RSEN: Repeated START Condition Enable bit (In I2C Master mode only)

= Initiate Repeated START condition on SDA and SCL pins. Automatically cleared by hardware.

= Repeated START condition idle

bit 0

SEN: START Condition Enable bit (In I2C Master mode only)

= Initiate START condition on SDA and SCL pins. Automatically cleared by hardware.

= START condition idle

Note:

For bits ACKEN, RCEN, PEN, RSEN, SEN: If the I2C module is not in the IDLE

mode, this bit may not be set (no spooling), and the SSPBUF may not be written (or

writes to the SSPBUF are disabled).

Legend:

R = Readable bit

W = Writable bit

U = Unimplemented bit, read as ‘0’

- n = Value at POR

’1’ = Bit is set

’0’ = Bit is cleared

x = Bit is unknown

PIC876 데이터시트(PDF) 70 Page - Microchip Technology

PIC876 데이터시트(HTML) 70 Page - Microchip Technology

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79 80 81 82 83 84 85 86 87 88 89 90 91 92 93 94 95 96 97 98 99 100 ...More

데이터시트 다운로드

링크 URL