Board 1 SKYPER

7

2010-04-21 – Rev01

© by SEMIKRON

Mounting Notes

Driver Core Mounting

2. Insert driver core into the box connector on adaptor board.

3. The connecting leads between board and power module should be as short as possible (max. 20cm), the leads should be twisted.

The connection between driver core and adaptor board should be

mechanical reinforced by using support posts. The posts have to be

spaced between driver core and adaptor board.

Product information of suitable support posts and distributor contact

information is available at e.g. http://www.richco-inc.com (e.g. part

number DLMSPM-8-01, LCBST-8-01).

DISCLAIMER

SEMIKRON reserves the right to make changes without further notice herein to improve reliability, function or design.

Information furnished in this document is believed to be accurate and reliable. However, no representation or warranty is

given and no liability is assumed with respect to the accuracy or use of such information. SEMIKRON does not assume

any liability arising out of the application or use of any product or circuit described herein. Furthermore, this technical

information may not be considered as an assurance of component characteristics. No warranty or guarantee expressed

or implied is made regarding delivery, performance or suitability. This document supersedes and replaces all information

previously supplied and may be superseded by updates without further notice.

SEMIKRON products are not authorized for use in life support appliances and systems without the express written

approval by SEMIKRON.

www.SEMIKRON.com