SPS-43-48H-CP-RDF

DS-5980 Rev 01 2013-08-23

Table 11 - Device Handling/ESD Protection

The devices are static sensitive and may easily be damaged if care is not taken during handling. The following handling practices are

recommended.

1

Devices should be handled on benches with conductive and grounding surfaces.

2

All personnel, test equipment and tools shall be grounded.

3

Do not handle the devices by their leads.

4

Store devices in protective foam or carriers.

5

Avoid the use of non-conductive plastics, rubber, or silk in the area where the devices are handled

6

All modules shall be packaged in materials that are anti-static to protect against adverse electrical environments.

7

Avoid applications of any voltage higher than maximum rated voltages to this part. For proper operation, any VIN or VOUT should be

constrained to the range GND

≤ (VIN or VOUT) ≤ VCC. Unused inputs must always be tied to an appropriate logic voltage (e.g.

either GND or VCC). Unused outputs must be left open.