| 전자부품 데이터시트 검색엔진 |
|
USB2642 데이터시트(PDF) 13 Page - Microchip Technology |
|
|
|||||||||||||||||||||||||||||
USB2642 데이터시트(HTML) 13 Page - Microchip Technology |
|
13 / 56 page ![]() 2014-2015 Microchip Technology Inc. DS00001578C-page 13 USB2642 5.3.2 PORT POWER CONTROL USING A POLY FUSE When using the USB2642 with a poly fuse, an external diode must be used (see Figure 5-2). When disabling port power, the USB2642 driver will drive a 0. This procedure will have no effect since the external diode will isolate the pin from the load. When port power is enabled, the USB2642 output driver is disabled, and the pull-up resistor is enabled which cre- ates an open drain output. This means that the pull-up resistor is providing 3.3 volts to the anode of the diode. If there is an over-current situation, the poly fuse will open. This will cause the cathode of the diode to go to zero volts. The anode of the diode will be at 0.7 volts, and the Schmitt trigger input will register this as a low resulting in an over-current detection. The open drain output does not interfere. FIGURE 5-1: PORT POWER CONTROL WITH USB POWER SWITCH USB2642 USB Power Switch 5 V USB Device PRTCTL3 EN OCS USB Power Switch 5 V USB Device PRTCTL2 EN OCS |
|
링크 URL |
| ALLDATASHEET 가 귀하에 도움이 되셨나요? [ DONATE ] |
Alldatasheet는? | 광고문의 | 운영자에게 연락하기 | 개인정보취급방침 | 링크 투 데이터시트 | 링크교환 | 제조사별 검색 All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |