USB5533B datasheet(14/71 Pages) MICROCHIP

14 / 71 page

USB5533B

DS00001680C-page 14

 2012 - 2015 Microchip Technology Inc.

4.1.2

OPERATION OF THE DUAL HI-SPEED READ SEQUENCE

The SPI controller also supports dual data mode (at 30 MHz SPI speed only). When configured in dual mode, the SPI

controller will automatically handle reads going out to the SPI ROM. When the controller detects a read, the controller

drops the SPI_CE_N, and puts out a 0x3B, followed by the 24-bit address. The SPI controller then puts out a DUMMY

byte. The next four clocks clock in the first byte. The data appears two bits at a time on data out and data in. When the

first byte is clocked in a ready signal is sent back to the processor, and the processor gets one byte.

After the processor gets the first byte, the address will change. If the address is one more than the last address, the SPI

controller will clock out one more byte. If the address in anything other than one more than the last address, the SPI

controller will terminate the transaction by taking SPI_CE_N high. As long as the addresses are sequential, the SPI Con-

troller will keep clocking in data.

FIGURE 4-2:

SPI HI-SPEED READ SEQUENCE

FIGURE 4-3:

SPI DUAL HI-SPEED READ OPERATION

SPI_CEN

SPI_CLK

SPI_DO

SPI_DI

MSB

HIGH IMPEDANCE

15 16

12 3 4

DOUT

ADD.

23 24

ADD.

39 40

31 32

47 48

55 56

63 64

71 72

DOUT

NN+1

DOUT

N+2

DOUT

N+3

DOUT

N+4

MSB

SPI

CONTROLLER

SPI

ROM

2-Serial to

8-Parallel

CE#

CLK

ADDRESS

CONTROL

CACHE

SPI_DI

USB Hub

USB5533B 데이터시트(PDF) 14 Page - Microchip Technology

USB5533B 데이터시트(HTML) 14 Page - Microchip Technology

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60 61 62 63 64 65 66 67 68 69 70 71

데이터시트 다운로드

링크 URL