| 전자부품 데이터시트 검색엔진 |
|
LAN8820I 데이터시트(PDF) 34 Page - Microchip Technology |
|
|
|||||||||||||||||||||||||||||
LAN8820I 데이터시트(HTML) 34 Page - Microchip Technology |
|
34 / 83 page ![]() LAN8820/LAN8820I DS00001871B-page 34 2009-2015 Microchip Technology Inc. 4.0 REGISTER DESCRIPTIONS This chapter describes the various control and status registers (CSR’s). All registers follow the IEEE 802.3 (clause 22.2.4) management register set. All functionality and bit definitions comply with these standards. The IEEE 802.3 spec- ified register index (in decimal) is included with each register definition, allowing for addressing of these registers via the Serial Management Interface (SMI) protocol. The device registers are categorized into following groups: • Primary PHY Registers • Advanced PHY Registers 4.1 Register Nomenclature Table 4-1 describes the register bit attributes used throughout this document. Many of these register bit notations can be combined. Some examples of this are shown below: • R/W: Can be written. Will return current setting on a read. • R/WAC: Will return current setting on a read. Writing anything clears the bit. TABLE 4-1: REGISTER BIT TYPES Register Bit Type Notation Register Bit Description R Read: A register or bit with this attribute can be read. W Write: A register or bit with this attribute can be written. RO Read only: Read only. Writes have no effect. WO Write only: If a register or bit is write-only, reads will return unspecified data. WC Write One to Clear: writing a one clears the value. Writing a zero has no effect. WAC Write Anything to Clear: writing anything clears the value. RC Read to Clear: Contents is cleared after the read. Writes have no effect. LL Latch Low: Clear on read of register. LH Latch High: Clear on read of register. SC Self-Clearing: Contents is self-cleared after the being set. Writes of zero have no effect. Contents can be read. RO/LH Read Only, Latch High: This mode is used by the Ethernet PHY registers. Bits with this attribute will stay high until the bit is read. After it a read, the bit will remain high, but will change to low if the condition that caused the bit to go high is removed. If the bit has not been read the bit will remain high regardless of if its cause has been removed. NASR Not Affected by Software Reset: The state of NASR bits does not change on assertion of a software reset. X Either a 1 or 0. RESERVED Reserved Field: Reserved fields must be written with zeros, unless otherwise indicated, to ensure future compatibility. The value of reserved bits is not guaranteed on a read. |
|
링크 URL |
| ALLDATASHEET 가 귀하에 도움이 되셨나요? [ DONATE ] |
Alldatasheet는? | 광고문의 | 운영자에게 연락하기 | 개인정보취급방침 | 링크 투 데이터시트 | 링크교환 | 제조사별 검색 All Rights Reserved©Alldatasheet.com |
| Russian : Alldatasheetru.com | Korean : Alldatasheet.co.kr | Spanish : Alldatasheet.es | French : Alldatasheet.fr | Italian : Alldatasheetit.com Portuguese : Alldatasheetpt.com | Polish : Alldatasheet.pl | Vietnamese : Alldatasheet.vn Indian : Alldatasheet.in | Mexican : Alldatasheet.com.mx | British : Alldatasheet.co.uk | New Zealand : Alldatasheet.co.nz |
|
Family Site : ic2ic.com |
icmetro.com |