R5975D datasheet(13/47 Pages) STMICROELECTRONICS

13 / 47 page

DocID026878 Rev 1

13/47

R5975D

Functional description

The synchronization feature, of a set of the R5975D, is simply obtained by connecting

together their SYNCH pins. The device with highest switching frequency is the master,

which provides the synchronization signal to the others. Therefore the SYNCH is an I/O pin

to deliver or recognize a frequency signal. The synchronization circuitry is powered by the

internal reference (VREF), so a small filtering capacitor (100 nF) connected between the

VREF pin and the signal ground of the master device is recommended for its proper

operation. However, when a set of synchronized devices populate a board it is not possible

to know in advance which is working as master, so the filtering capacitor must be designed

for a whole set of devices.

When one or more devices are synchronized to an external signal, its amplitude must be in

compliance with specifications given in Table 4 on page 8. The frequency of the

synchronization signal must be, at a minimum, higher than the maximum guaranteed natural

switching frequency of the device (275 kHz, see Table 4) while the duty cycle of the

synchronization signal can vary from approximately 10% to 90%. The small capacitor under

the VREF pin is required for this operation.

Figure 4. Oscillator circuit block diagram

R5975D 데이터시트(PDF) 13 Page - STMicroelectronics