M95080-DRMF4TP datasheet(24/42 Pages) STMICROELECTRONICS

24 / 42 page

Instructions

M95080-A125 M95080-A145

24/42

DocID024205 Rev 8

The Read Lock Status instruction is not accepted and not executed if a Write cycle is

currently in progress.

Figure 14. Read Lock Status sequence

4.10

Lock Identification Page (LID)

The Lock Identification Page (LID) command is used to permanently lock the Identification

Page in Read-only mode.

The LID instruction is issued by driving Chip Select (S) low, sending (MSB first) the

instruction code, the address and a data byte on Serial Data input (D), and driving Chip

Select (S) high. Address bit A7 must be equal to 1. All other address bits are Don't Care (it

might be easier to define these bits as 0, as shown in Table 7). The data byte sent must be

equal to the binary value xxxx xx1x, where x = Don't Care. The LID instruction is terminated

by driving Chip Select (S) high at a data byte boundary, otherwise, the instruction is not

executed.

Figure 15. Lock ID sequence

Driving Chip Select (S) high at a byte boundary of the input data triggers the self-timed Write

cycle which duration is tW (specified in Table 15). The instruction sequence is shown in

Figure 15.

M95080-DRMF4TP 데이터시트(PDF) 24 Page - STMicroelectronics