SRTAG2KL datasheet(24/51 Pages) STMICROELECTRONICS

24 / 51 page

RF command sets

SRTAG2KL

24/51

DocID026583 Rev 2

5.4

S-Block format

The S-Block is used to exchange control information between a reader and a contactless

tag.

There are two requests using the S-Block format:

•

S(DES): the deselect command

•

S(WTX): the Waiting Frame eXtension command or response.

A Waiting Time eXtension request occurs in RF when the operating time needed by

SRTAG2KL is greater than 19.2 ms.

The WTX field indicates the increase time factor to be used in this command execution

(FDTtemp = WTX * 19.2 ms). WTX depends on FWI.

Table 16. R-Block detailed format

b7-b6

b5b4b3

0b10

R-Block

Must be set to 1.

0: NAK

1: ACK

0: DID field is not present

1: DID field is present

Must be set to 0

Block number

Table 17. S-Block format

NFC frame

SoD

EoD

PCB

DID

Payload

CRC

Length

1 byte

2 bytes

0xC2: for S(DES) when the DID field is not

present

0xCA: for S(DES) when the DID field is present

0xF2: for S(WTX) when the DID field is not

present

0xFA: for S(WTX) when the DID field is present

DID field (optional)

WTX field (optional)(1)

1. This field is present when b5-b4 bits are set to 0b11 (S-Block is a WTX). see Table 18: S-Block detailed

format.

2 CRC bytes

SRTAG2KL 데이터시트(PDF) 24 Page - STMicroelectronics

SRTAG2KL 데이터시트(HTML) 24 Page - STMicroelectronics

Html Pages

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44 45 46 47 48 49 50 51

데이터시트 다운로드

링크 URL